Home > News > Content

How To Choose A Reasonable Amount Of CNC Prototyping Processing

Oct 26, 2017

How to choose a reasonable amount of CNC Prototyping processing
Reasonable choice of CNC Prototyping processing costs, and machine tools, tools, parts and processes and other factors have a great relationship, CNC Prototyping manufacturers to introduce you how to choose a reasonable amount of processing.
If roughing, you need to ensure high production efficiency, CNC Prototyping manufacturers recommend the choice of a larger amount of back to eat knife a, to ensure a larger feed, cutting speed U can choose low speed. And finishing, you need to ensure the size of the parts and surface accuracy, manufacturers recommend the choice of a small amount of back to eat knife ap, to ensure a smaller feed, cutting speed U can choose a higher speed.
In addition, CNC prototyping roughing, the general should give full play to the potential of the machine and cutting tool cutting capacity. If it is semi-finishing and finishing, should focus on how to ensure the quality of processing and improve production efficiency. When selecting the amount of cutting, make sure that the tool can complete a part or ensure that the durability of the tool is not less than one working class, at least half of the time of the work class.
CNC Prototyping is used for workpiece processing commonly used equipment, which is different from the traditional machine tool equipment, its own has many characteristics, CNC Prototyping manufacturers for you to fine.
CNC Prototyping processing accuracy than traditional machine tools in the workpiece processing quality is also more stable, which is one of the reasons people choose it. With the progress of technology, CNC Prototyping manufacturers of equipment can be multi-coordinate linkage, for some complex parts can also be processed, which is the traditional machine can not be achieved. If you encounter changes in the processing of parts, only need to change the NC program can save a lot of processing time and improve the processing efficiency.
CNC Prototyping itself, the higher accuracy, greater rigidity, you can choose a favorable amount of processing, higher productivity, is about 3-5 times the normal machine, its efficiency can not be underestimated. Technological progress is brought about by the increase in the degree of automation, the labor intensity of workers to be reduced, the number of operators on each device is also reduced, to some extent also save the human resources. Finally, with the improvement of equipment performance, the quality of the operator is relatively to improve the maintenance staff of the technology as well.
CNC Prototyping is the most commonly used equipment in the workpiece processing, the processing of high efficiency, good quality, so many users, but CNC Prototyping manufacturers to remind you, in order to normal use of CNC Prototyping, you have to meet the following conditions of use.
On the environmental side, the location of the CNC Prototyping to stay away from the vibration source, to prevent direct sunlight and heat radiation, but also to prevent the machine by the impact of wet air. For the location of the vicinity of the vibration source, manufacturers can be set around the machine anti-vibration ditch.
In terms of power, because most of the processing plant temperature changes, the use of conditions are poor, coupled with a variety of mechanical and electrical equipment, resulting in large fluctuations in the grid. Therefore, the location of the installation of CNC Prototypings to strictly control the power supply to ensure that the power supply voltage fluctuations within the allowable range, and remain relatively stable.
Finally, the temperature conditions, CNC Prototyping manufacturers recommend that you use the ambient temperature below 30 degrees Celsius, the relative temperature of less than 80%. CNC electric control box inside the exhaust fan or chillers, which can keep the electronic component temperature is constant or small temperature difference, the temperature is too high will lead to lower control device life and more failure, but also easily lead to short circuit problems, so the processing should be strict control.